Free Download Foxit Reader Pro Pack there. Maybe just the bulb needs replacing, maybe an internal fuse blown? Might be a track burned open on the pcb, maybe a transistor gone. Open it up and have a look if anything is obviously cooked. Check you have Voltage on the plug that goes into the meter.

I have an SX-200 which the bulb eventually blew, I replaced it with a white LED & a resistor (whenever I replace a bulb I do this now). The supply Voltage (13.8Volts) minus the LED Voltage drop (2Volts) divided by the desired current (usually 30mA) gives the resistor value needed. (13.8 - 2) / 0.030 = about 390 Ohms I found a calculator if it's any easier. 5B4AJB, Dem, Thanks for your reply. According to the wiring schematic there is a resistor in series with each bulb(2) but a good point, thanks. My real concern is twofold. First the PEP LED does not light when the unit is switched to PEP.

Second, I have the SWC-1 plugged into receptacle 'A' for 2 meter and the unit set for coupler 'A' and all works correctly but when I switch to coupler B or C (which have no couplers attached) the transceiver plugged through the A coupler still works. This seems like a short circuit. Shouldn't the Peak Envelope Power pilot light light up when that level is reached (when you speak on SSB)? Follow the internal circuit with an Ohm-meter to see if nothing's blown. Then plug it in and follow it with a Volt meter. Right, I see what you have now, just Googled your meter. It uses antenna couplers, so in theory you can have 3 separate coax runs remotely connected.

Free Download Powerdvd Se Dvd Decoder Xp. KENWOOD SW 2000 SWR POWER METER TROUBLE MANUAL - Radio Communications question. Feb 10, 2009 Good conditions SWR / POWER METER SOLD Range Freq 140-520 MHz MANUAL BOOK Can be use 3 sensors (optional) Black box can be remove, and install them near. KENWOOD SWR Power Meter SW-200 & Sw-2 Vintage Ham Radio Equipment Works - CAD $279.97. Items shown included in sale. May 05, 2017 Kenwood sw 2000 repair. Kenwood sw 2000 meter repair. I downloaded a copy of the manual for it on line and it seems to me it.

The SWC-1 coupler works from 1.8MHz to 150Mhz. Unless you have coupler B & C connected, the meter would be open circuit, inadvertently damaging a transceiver, Kenwood probably short them when unplugged for this reason. 5B4AJB, Dem, Again thanks for your reply. Remember I'm new to Ham Radio. I have some electronics. The manual isn't very detailed but what you are saying is the light would not come on just because the switch is set to PEP only if PEP has been reached.

Download Ratatouille Ps2 Iso Torrents. I just watched a YouTube video and the PEP light does come on when PEP is selected. I don't get a reading or a light when PEP is switched on so I may have an open circuit in the 13.8v power feed. All non-powered modes work. So I will diagnose the 13.8v input circuits. 73 de KF5AOG.